Combined Cycle......

Combined cycle is an electric generating technology that creates additional electricity from heat exiting gas turbines. The exhaust heat from the gas turbines is routed to a conventional boiler or to a heat recovery steam generator for utilization by a steam turbine in the production of electricity.
Where natural gas is abundant and cheap, combining the Brayton (gas) and Rankine (steam) cycles to generate electricity has many advantages. Among these is natural gas, a relatively clean-burning fuel, emitting far less CO2,, mercury and particulate emissions than coal. In a combined cycle power plant, a waste heat boiler is installed onto the gas turbine exhaust stream. This heat recovery steam generator (HRSG) produces steam from hot gas exhaust to drive a steam turbine that turns an electric generator.
Flowserve pumps, valves and seals are fully proven and ideally suited for combined cycle project applications, including co-generation of electrical power and steam. These applications include heat recovery steam generator (HRSG) feed water, condensate and circulating water as well as auxiliary services...

In electric power generation a combined cycle is an assembly of heat engines that work in tandem from the same source of heat, converting it intomechanical energy, which in turn usually drives electrical generators. The principle is that the exhaust of one heat engine is used as the heat source for another, thus extracting more useful energy from the heat, increasing the system's overall efficiency. This works because heat engines are only able to use a portion of the energy their fuel generates (usually less than 50%). In an ordinary (non combined cycle) heat engine the remaining heat (e.g., hot exhaust fumes) from combustion is generally wasted.

Combining two or more thermodynamic cycles results in improved overall efficiency, reducing fuel costs. In stationary power plants, a widely used combination is a gas turbine (operating by the Brayton cycle) burning natural gas or synthesis gas from coal, whose hot exhaust powers a steam power plant (operating by the Rankine cycle). This is called a Combined Cycle Gas Turbine (CCGT) plant, and can achieve a thermal efficiency of around 60%, in contrast to a single cycle steam power plant which is limited to efficiencies of around 35-42%. Many new gas power plants in North America and Europe are of this type. Such an arrangement is also used for marine propulsion, and is called a combined gas and steam (COGAS)plant. Multiple stage turbine or steam cycles are also common.

Other historically successful combined cycles have used hot cycles with mercury vapor turbines, magnetohydrodynamic generators or molten carbonate fuel cells, with steam plants for the low temperature "bottoming" cycle. Bottoming cycles operating from a steam condenser's heat exhaust are theoretically possible, but uneconomical because of the very large, expensive equipment needed to extract energy from the small temperature differences between condensing steam and outside air or water. However, it is common in cold climates (such as Finland) to drive community heating systems from a power plant's condenser heat. Such cogeneration systems can yield theoretical efficiencies above 95%.

In automotive and aeronautical engines, turbines have been driven from the exhausts of Otto and Diesel cycles. These are called turbo-compound engines (not to be confused with turbochargers). They have failed commercially because their mechanical complexity and weight are less economical than multistage turbine engines. Stirling engines are also a good theoretical fit for this application. A turbocharged car is also a combined cycle.